Close-up: American Vox Amps -VOX Logo Air Vents

American Vox amplifiers used a series of injection molded plastic air vents that were closely patterned after similar, but metal vents installed by JMI on British Vox amps.

The US vents had two molded plastic end pins that passed through mounting holes in the top of the head cabinet. A soldering iron was used to "mushroom" the ends of the vents to secure them to the cabinet.

In 2004, North Coast Music had injection molding tooling developed in the US to make a perfect reproduction of these American Vox parts from the 1960s. This part is produced by, and available exclusively at North Coast Music under license to Vox UK. Click here to go to the North Coast Music web page that offers this Vox vent.

North Coast Music manufactures many replacement and restoration

parts for the Super Beatle under license from Vox. These parts are
available exclusively at North Coast Music. Some are shown below.


The VOX Showroom!

Photos and editorial content courtesy Gary Hahlbeck, North Coast Music

Any and all material presented herein is protected by Copyright.
© 1998 - 2023 The Vox Showroom and North Coast Music, all rights reserved

The images and editorial content in this web site may not be copied or reproduced
in online auction sites such as eBay, Reverb and Craig's List. Sellers may provide a link
to the Vox Showroom web site if they wish to refer to this copyrighted material.